| 1 | # SPDX-License-Identifier: GPL-2.0-only |
| 2 | menu "EEPROM support" |
| 3 | |
| 4 | config EEPROM_MAX6875 |
| 5 | tristate "Maxim MAX6874/5 power supply supervisor" |
| 6 | depends on I2C |
| 7 | help |
| 8 | If you say yes here you get read-only support for the user EEPROM of |
| 9 | the Maxim MAX6874/5 EEPROM-programmable, quad power-supply |
| 10 | sequencer/supervisor. |
| 11 | |
| 12 | All other features of this chip should be accessed via i2c-dev. |
| 13 | |
| 14 | This driver can also be built as a module. If so, the module |
| 15 | will be called max6875. |
| 16 | |
| 17 | |
| 18 | config EEPROM_93CX6 |
| 19 | tristate "EEPROM 93CX6 support" |
| 20 | help |
| 21 | This is a driver for the EEPROM chipsets 93c46 and 93c66. |
| 22 | The driver supports both read as well as write commands. |
| 23 | |
| 24 | If unsure, say N. |
| 25 | |
| 26 | config EEPROM_DIGSY_MTC_CFG |
| 27 | bool "DigsyMTC display configuration EEPROMs device" |
| 28 | depends on GPIO_MPC5200 && SPI_GPIO |
| 29 | help |
| 30 | This option enables access to display configuration EEPROMs |
| 31 | on digsy_mtc board. You have to additionally select Microwire |
| 32 | EEPROM 93XX46 driver. sysfs entries will be created for that |
| 33 | EEPROM allowing to read/write the configuration data or to |
| 34 | erase the whole EEPROM. |
| 35 | |
| 36 | If unsure, say N. |
| 37 | |
| 38 | config EEPROM_IDT_89HPESX |
| 39 | tristate "IDT 89HPESx PCIe-switches EEPROM / CSR support" |
| 40 | depends on I2C && SYSFS |
| 41 | help |
| 42 | Enable this driver to get read/write access to EEPROM / CSRs |
| 43 | over IDT PCIe-switch i2c-slave interface. |
| 44 | |
| 45 | This driver can also be built as a module. If so, the module |
| 46 | will be called idt_89hpesx. |
| 47 | |
| 48 | endmenu |