| 1 | # SPDX-License-Identifier: GPL-2.0-only |
| 2 | |
| 3 | if ARCH_ASPEED || COMPILE_TEST |
| 4 | |
| 5 | menu "ASPEED SoC drivers" |
| 6 | |
| 7 | config ASPEED_LPC_CTRL |
| 8 | tristate "ASPEED LPC firmware cycle control" |
| 9 | select REGMAP |
| 10 | select MFD_SYSCON |
| 11 | default ARCH_ASPEED |
| 12 | help |
| 13 | Control LPC firmware cycle mappings through ioctl()s. The driver |
| 14 | also provides a read/write interface to a BMC ram region where the |
| 15 | host LPC read/write region can be buffered. |
| 16 | |
| 17 | config ASPEED_LPC_SNOOP |
| 18 | tristate "ASPEED LPC snoop support" |
| 19 | select REGMAP |
| 20 | select MFD_SYSCON |
| 21 | default ARCH_ASPEED |
| 22 | help |
| 23 | Provides a driver to control the LPC snoop interface which |
| 24 | allows the BMC to listen on and save the data written by |
| 25 | the host to an arbitrary LPC I/O port. |
| 26 | |
| 27 | config ASPEED_UART_ROUTING |
| 28 | tristate "ASPEED uart routing control" |
| 29 | select REGMAP |
| 30 | select MFD_SYSCON |
| 31 | default ARCH_ASPEED |
| 32 | help |
| 33 | Provides a driver to control the UART routing paths, allowing |
| 34 | users to perform runtime configuration of the RX muxes among |
| 35 | the UART controllers and I/O pins. |
| 36 | |
| 37 | config ASPEED_P2A_CTRL |
| 38 | tristate "ASPEED P2A (VGA MMIO to BMC) bridge control" |
| 39 | select REGMAP |
| 40 | select MFD_SYSCON |
| 41 | default ARCH_ASPEED |
| 42 | help |
| 43 | Control ASPEED P2A VGA MMIO to BMC mappings through ioctl()s. The |
| 44 | driver also provides an interface for userspace mappings to a |
| 45 | pre-defined region. |
| 46 | |
| 47 | config ASPEED_SOCINFO |
| 48 | bool "ASPEED SoC Information driver" |
| 49 | select SOC_BUS |
| 50 | default ARCH_ASPEED |
| 51 | help |
| 52 | Say yes to support decoding of ASPEED BMC information. |
| 53 | |
| 54 | endmenu |
| 55 | |
| 56 | endif |